User guide
Table Of Contents
- Version: V2.7.1.2
- Contents
- 1 INSTALLATION and OVERVIEW
- 2DEVICE CONNECTION
- 3ENGINEERING RESOURCES
- 4MANAGING PROFILES
- 5MANAGING LOGGED DATA
- 6CONFIGURING DATALOGGERS
- 6.1 Introduction
- 6.2 DS-CPU3 Configuration
- 6.3 DS-4483 Configuration
- 6.3.1 DS-4483 Sensor Configuration Settings
- 6.3.1.1 Retrieving the Datalogger Configuration
- 6.3.1.2 Transferring Configuration Settings to the DS-4483
- 6.3.1.3 Loading a Template into iLink
- 6.3.1.4 Saving a Template to file
- 6.3.1.5 Printing Template Information
- 6.3.1.6 Sensor Selection
- 6.3.1.7 General Setup
- 6.3.1.8 I/O Setup
- 6.3.1.9 Scaling Setup
- 6.3.1.10 Timing/Misc Setup
- 6.3.1.11 Alarms Setup
- 6.3.1.12 Output Setup
- 6.3.1.13 Comment Setup
- 6.3.2 Telemetry Communications Control Configuration
- 6.3.4 New Sensor Wizard
- 6.3.1 DS-4483 Sensor Configuration Settings
- 7LOADING PROGRAMS
- 8DEVICE CALIBRATION
- APPENDIX A
- APPENDIX B
- APPENDIX C
- APPENDIX D
50 iLink - Configuration and Support Utility
iQuest (NZ) Ltd - PO Box 15169 HAMILTON Tel: +64 7 957 8160 - Fax: +64 7 957 8162 - Email: iquest@iquest.co.nz
6.3.4 New Sensor Wizard
The New Sensor Wizard is the recommended method of adding new sensors to a device template. It will
take the user through a number of simple steps and then create the sensor using the supplied information
and any necessary defaults. The sensor configuration can then be reviewed and, if necessary,
customised as appropriate. The stages of the wizard are outlined below.
Starting the New Sensor Wizard
Open the DS-4483 Configuration Window [Configuration][DS-4483 Logger]
1. Select an empty sensor location (or [Clear] an existing sensor location.). In the screenshot above,
sensor location number 04 has been selected by clicking on the ‘04’ in the Sensor Selection window.
2. Click on [New Sensor Wizard]
The wizard will launch and you will be asked to confirm that you wish to begin the wizard.
3. Click [Next] to continue.
At any stage of the wizard you can click [Back] to review/change your settings or
click [Cancel] to exit the wizard.