User guide

iQuest (NZ) Ltd - PO Box 15169 HAMILTON Tel: [phone] - Fax: [phone] - Email:
iLink - Configuration and Support Utility 5
[e-mail]
1 INSTALLATION and OVERVIEW
1.1 Introduction
Thank you for purchasing iLink. iLink is a utility program used for communicating with the range of System
DO
®
products manufactured by iQuest (NZ) Ltd. This program is used for:
 Configuring the device
 Setting the device’s address
 Loading firmware
 Loading application programs
 Writing/editing application programs
 Downloading logged data
 Viewing logged data
 Hardware and software diagnostics
The range of options available to the User will vary from device to device.
1.1.1 Supported System DO
®
Products
System DO
®
products supported include:
DS-CPU3 Controller
DS-4483 Datalogger
DS-12840i Remote Telemetry Unit
IRIS 300 GPRS Equipped Datalogger
1.1.2 Unsupported System DO
®
Products
The following System DO
®
products not supported by iLink are:
DS-CPU2 DO Station
DS-IRM Intelligent Radio Modem
DS-CP/I Communications Protocol Interface
DS-8840i Remote Telemetry Unit
DS-RTU Remote Telemetry Unit
DS-PS1 Pico Station
For these legacy or specialist products, use the DOS support tool, Manage.