User guide
Table Of Contents
- Version: V2.7.1.2
- Contents
- 1 INSTALLATION and OVERVIEW
- 2DEVICE CONNECTION
- 3ENGINEERING RESOURCES
- 4MANAGING PROFILES
- 5MANAGING LOGGED DATA
- 6CONFIGURING DATALOGGERS
- 6.1 Introduction
- 6.2 DS-CPU3 Configuration
- 6.3 DS-4483 Configuration
- 6.3.1 DS-4483 Sensor Configuration Settings
- 6.3.1.1 Retrieving the Datalogger Configuration
- 6.3.1.2 Transferring Configuration Settings to the DS-4483
- 6.3.1.3 Loading a Template into iLink
- 6.3.1.4 Saving a Template to file
- 6.3.1.5 Printing Template Information
- 6.3.1.6 Sensor Selection
- 6.3.1.7 General Setup
- 6.3.1.8 I/O Setup
- 6.3.1.9 Scaling Setup
- 6.3.1.10 Timing/Misc Setup
- 6.3.1.11 Alarms Setup
- 6.3.1.12 Output Setup
- 6.3.1.13 Comment Setup
- 6.3.2 Telemetry Communications Control Configuration
- 6.3.4 New Sensor Wizard
- 6.3.1 DS-4483 Sensor Configuration Settings
- 7LOADING PROGRAMS
- 8DEVICE CALIBRATION
- APPENDIX A
- APPENDIX B
- APPENDIX C
- APPENDIX D
iQuest (NZ) Ltd - PO Box 15169 HAMILTON Tel: +64 7 957 8160 - Fax: +64 7 957 8162 - Email:
iLink - Configuration and Support Utility 37
iquest@iquest.co.nz
6.3 DS-4483 Configuration
[Configuration][DS-4483 Logger]
This section deals with configuring Templates for the DS-4483. Templates are used to manage the
sensor and I/O configurations loaded into the device. Connection settings such as baud rate, dial-up
telephone number, modem configuration etc are contained in the profile for the device
When creating and configuring new sensors for a device it is recommended that you begin by following
the New Sensor Wizard. You can then check and modify any settings as appropriate by referring to the
following configuration guide.
Selecting [Configuration] [DS-4483] from the menu opens the template configuration window. If the device
is attached to an existing template, the following will be displayed:
Select [Yes] to load the template into iLink or select [No] to load a ‘blank’ template.
The template configuration dialog will then be displayed.