Instruction Manual

Installation, Operating and Maintenance Instruction Model MP, MPA, MPAI
MP 100-english page 92 Revision 04
Article No 771074011 Issue 11/2011
 Removing the shaft seal: See "Replacing the
Shaft Seal".
 Clean all parts. If the pump is to be reassembled
at a later date, carefully store all parts and protect
from corrosion.
8.9 Repairs
Clean all parts and check for wear. In case of
excessive wear, parts must be replaced. This is a
practical opportunity to renew parts such as seals (O-
rings), roller bearings and shaft seals.
Wearing parts and dimensions:
A B C D E F A
G