User guide

Electrical Connections continued

Step 3 - Wiring the

AQUAVAR

controller to motor

(Parts in the electrical fittings package will be required for this procedure.) Refer to Diagram 3

before proceeding.

1. Remove the three screws holding the top of the AQUAVAR controller. Carefully lift off the cover

of the AQUAVAR controller.

2. Remove the screw holding the ground wire to the inside of the top of the AQUAVAR controller.

Set cover aside.

3. Motor Lead Connections

Locate the terminal block labeled U, V, W, and ground screw inside the AQUAVAR controller

(Diagram 5).

Connect wires to terminal block and route wires through one of the ports on the

bottom half of the AQUAVAR controller. (Refer to Diagram 5).

Installation Procedures