OPERATION MANUAL ba76147e01 ® MultiLab User PC SOFTWARE FOR USER ADMINISTRATION 04/2013
MultiLab® User 2 ba76147e01 04/2013
MultiLab® User Contents MultiLab® User - Contents 1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2 Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2.1 System requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2.2 Installing the MultiLab User program on the PC . . . . . . . . . . . . . . . . 4 2.3 Connecting the meter with the PC. . . . . . . . . . . . . . . . . . . . . . . . . . . 5 3 3.
MULTILAB® USER OVERVIEW MultiLab User 1 Overview The MultiLab User PC program adds the user administration function to the features of your meter. After activation of the user administration by the administrator, measurements are only possible after login with a user name. The user name is documented with the measured values and in records. The user administration is swapped out to the PC.
MULTILAB® USER OPERATION 2.3 Connecting the meter with the PC A USB cable is required for this connection (type A - type B). The MultiLab User program recognizes the suitable meters. 3 1. Connect the meter to the PC with a USB cable. 2. Switch on the meter. Operation 3.1 ba76147d01 04/2013 Activating the user administration on the meter 1. Connect the meter to the PC. 2. Switch on the meter. The meter displays the start window. A measured value is displayed if a sensor is connected. 3.
MULTILAB® USER OPERATION A password consists of 4 digits. 7. Enter the password and confirm with OK. The password is displayed hidden. The list of users is read out from the meter and displayed on the PC. If you use theMultiLab User program for the first time: • Enter a new password here. This password is assigned to the user name, Admin P. It enables access to the meter with the user name Admin P and access to the user administration on the PC. • Confirm with OK.
MULTILAB® USER OPERATION Activate the user administration in the meter with Activate. A progress bar is displayed while the data are being transmitted. The meter will then restart. The Login menu is displayed. Before you can measure with the meter, first select a user name and enter a password as necessary. 10. 3.2 User administration 2 1 3 4 6 5 7 8 1 Send the displayed list of user with the setting for the password (P) to the meter (Send) The list of users is sent to the meter.
MULTILAB® USER WHAT TO DO IF... 4 What to do if... 4.1 No connection to meter Cause Remedy USB cable defective Use another USB cable Baud set on the meter is too high • Set lower baud rate on the meter (menu, System/interface) • Quit the setting menu • Restart the MultiLab User program. • Re-establish the connection USB VCP driver is not installed 4.2 Install USB VCP driver User administration cannot be set up Cause The firmware version of the meter does not support this feature 4.
