Owner's manual

USERS MANUAL
CHATTER™ DATA LOGGER
8
Initial setup
The initial setup - or physical setup - of a Chatter™ Data Logger consists of some steps. Which steps depends on
your model of Chatter™ Data Logger:
Panel mount model
Tube mount model
Unpack the Chatter™ Data Logger
Additional information:
Package content, panel mount model
Unpacking the Chatter™ Data Logger
Additional information:
Package content, tube mount model
Opening the Chatter™ Data Logger
Additional information:
Open the panel mount Chatter™ Data Logger
Opening the Chatter™ Data Logger
<%ADDINFO%
Open the Chatter Data logger
Insert cable glands
Additional information:
Insert cable glands, panel mount model
Not needed, the sensor connects with an
electrical plug.
Connect the antenna
Additional information:
Connect the antenna, panel mount model
Not needed, the internal antenna is already
connected.
Insert SIM-card,
Additional information:
Insert a SIM-card, panel mount model
Insert SIM-card,
Additional information:
Insert a SIM-card, tube mount model
Connect sensors
Additional information:
Connecting sensors
Connect sensors
Additional information:
Connect sensor
Turn on the Chatter™ Data Logger
Additional information:
Turn on the Chatter Data logger
Turn on the Chatter™ Data Logger
Additional information:
Turn on the Chatter Data logger
Configure the Chatter™ Data Logger using Chatter™
Link
Additional information:
Configuration with Chatter Link
Configure the Chatter™ Data Logger using
Chatter™ Link
Additional information:
Configuration with Chatter Link
Re-assemble the Chatter™ Data Logger.
Additional information:
Re-assemble the Chatter Data logger
Mount the Chatter™ Data Logger at its working
location
Additional information:
Mounting in the field
Mount the Chatter™ Data Logger at its working
location
Additional information:
Mounting in the field
10 23
11 24
12
13
14 25
15 29
20 26
44 44
31
21 27