INSTRUCTION MANUAL 6-71-075-109 REVISION A Autocirc® Instant Hot Water Pump Model: ACT E10
Preparation for Installation: Assemble the parts and tools required: 1. Open and inspect Autocirc pump package. 2. Autocirc pump package includes the pump with a built-in ti mer, a 6ft. cord, and wall mounting bracket. 3. Two stainless steel flexible hoses (1/2” x 3/8”) - length as required. (sold separately) 4. Adjustable wrench and screwdriver. 5. Select the sink under which the Autocirc pump is to be located (the sink where hot water takes longest to arrive).
Remove the existing flexible line connection to the hot and cold water faucet/tap threaded nipples (see Fig. 3). (TIP: Mark the hot and cold water flexible lines to easily identify them). Note: If necessary, replace the existing flexible hoses with new stainless steel braided flexible hoses in the lengths required. Step 4 Screw on the two existing 1/2” hose connections to the corresponding hot and cold sides of the pump housing (see Fig. 4).
Note: The above installation method applies to most situations where faucets/taps are connected to the hot and cold water supply lines with braided flexible hose/shut off valve arrangements. If the under sink arrangement is different (i.e. the risers are hard copper or plastic), then other parts may be required for the installation.
Xylem Inc. 3878 S. Willow, Suite 104 Fresno, CA 93725 Tel: (559) 265-4730 (800) 554-6853 Fax: (559) 265-4740 (800) 453-7523 www.xyleminc.com/brands/laingthermotech Laing Thermotech is a trademark of Xylem Inc. or one of its subsidiaries. © 2012 Xylem, Inc.
