Owner's manual

Omron Touch-Screen Display

N80:31 is the delay time until Fill starts. This is normally set to 10 seconds.

N80:32 is the delay time until Fill stops. This is also normally set to 10 seconds.

One other function is defined on this screen—Flow Activated PLC Relays. Depending on the

equipment connected to the relay, such as a fertigation relay, these two outputs can be used to set up

a minimum station flow required for operation.

N84:0 is the Flow Activated PLC Relay 1. The default is 100 GPM.

N84:1 is the another Flow Activated PLC Relay 1 that is rarely used. The default is 0 GPM.

Tap the value field next to any of these registers and the calculator/keypad pops-over the screen.

Enter or edit the value. (See also, Calculator/Keypad.)

Optionally, press the Main Menu touch key to return to the Main Menu. (See also, Main Menu.)

Optionally, press Back to return to the Register Access screen.

Press the up

(

▲

)

or down arrow

(

▼

)

key to display other Accessories parameters screens.

2.11 Define My Filter Parameters

You can access the Accessories screen and define your Filter parameters by pressing the Register

Access touch key on the Main Menu and opening the Register Access screen.