Owner's manual

How Do I?

Enter a time in seconds in the T4:28 Pre field. Default delay time is 50 seconds for the Time until

dP (Differential Pressure) fault used on the Torpedo and scanner filters.

Enter a time in seconds in the T4:40 Pre field. Default delay time is 3 seconds for the VFD run

feedback fault.

Enter a time in seconds in the T25:30 Pre field. Default delay time is 1 seconds for the Combo

overlap during change.

Tap the value field next to any of these registers and the calculator/keypad pops-over the screen.

Enter or edit the value. (See also, Calculator/Keypad.)

Press the up arrow

(

▲

)

in the bottom right corner of the screen to open the previous

screen, Timer Access page 1.

2.7 Define Lockout, Timed Pump, and Well Pump

Parameters

You can access the Lockout register screens and define your lockout parameters by pressing the