Owner's manual

108

Omron Touch-Screen Display

Use the Hexadecimal Equivalent Table to determine the number needed. (See, Check My Inputs

and Outputs.)

Optionally, press the Main Menu touch key to return to the Main Menu. (See also, Main Menu.)

Optionally, press Back to return to the previous screen, N Register Access.

Press the down arrow

(

▼

)

in the bottom right corner of the screen to advance to the Output

I/O Data: N50:64 to N50:127 screen. (See also, Changing an Output for information.)

2.16.2 Changing an Output

Just like the inputs, output values start at the top left hand corner (N50:64 cell is highlighted below).

You read the table from left to right and then down to the left-most value on the next line— just like

reading a book. Unused parameters are displayed as FFFF.

Note:

Hexadecimal or "hex" numbering uses a base (radix) of sixteen (see table below).

Programmers uses hex numbers as a way to represent binary numbers. A byte is

represented as two consecutive hexadecimal numbers. When converting numbers,

each digit is considered individually.

Press the I/O Control Data touch key on the N Register Access screen to take you to the Output

I/O Data: N50:64 to N50:127 screen.

Click on a value to open the calculation/keypad pop-over. Note that this version of the keypad

shows the alphabetic keys, A through F, needed to enter hex numbers.