Owner manual

AQUAFORCE Installation, Operation, and Maintenance

Operation

5.4 Hand Manual Operation

1. If system is running press the START/STOP key to stop the system. The solid green LED for start/stop

will turn off and any running pumps will stop.

2. Press the AUTO/MANUAL key and the screen will display the following:

< >

Manual Speed: #%

STAT1 STAT2 STAT3

3. If the PUMP LED is not ashing green, enable a pump to run in manual by pressing the

PUMP 1 or PUMP 2 key.

4. Press the START/STOP key to run the enabled pump(s) in manual. After a brief time delay the

pump(s) starts, and the ashing green LED(s) for pump(s) will turn solid green.

5. Press the UP (▲) key to increase pump speed to a maximum of 100% of rated speed. Press the

DOWN (▼) key to decrease the speed to 0% where the pump will run at the minimum speed

congured in the VFD, typically 30 HZ.

6. Press the START/STOP key to stop the system. The running pump(s) will stop.

5.5 Setpoint Modication

To modify the setpoint, press the SETPT/2 key. The following SET POINT SELECTION screen will be

displayed:

Selection: # 0=Exit

1= Set Point

3= Control Set Point

Use the appropriate numeric key to select the desired menu, then press the ENTER key. A detailed description

of each menu follows. For example, to select the SET POINT menu, press the PV/1 key and then press the

ENTER key. The following menu will be displayed:

SP1= ##

Exit: $ (Y/N)

If you agree with the current setpoint settings press the YES/7 key followed by ENTER. If you would like

to modify the setpoint press the NO/0 key followed by ENTER at which point the setpoint in the upper left

portion of the screen will begin ashing.

Press the numeric key to modify the setpoint and press ENTER.

After modifying the set point, press the YES/7 key to accept the values and return to the SET POINT

SELECTION screen.

To select the CONTROL SET POINT menu, press the SETUP/3 key and then press the ENTER key. The

following menu will be displayed:

Control Selection: #

1= Set Point

3 = Com Ovrd Exit $(Y/N)

The displayed # value indicates the current active method for set point. To change the active control method,

press the NO/0 key and then press the ENTER key.

The Control Selection eld will start blinking. Change the current value by pressing desired numeric Keys and

then press ENTER key to conrm. Press the YES/7 key and ENTER key to accept the selection and return to

the SET POINT SELECTION screen.