Owner manual

AQUAFORCE Installation, Operation, and Maintenance
27
Installation
4.10.18 Save to ash
The Save To Flash screen is displayed below:
SAVE TO FLASH
Previously Saved Data
Will be overwritten!
PROCEED: $(Y/N)
Press YES and ENTER to save all of the user setup to the ash memory. Saving to ash will overwrite any data
that was previously saved. Saving to ash memory will save all setup information to the Flash PROM chip within
the controller
A load from ash will have to be performed to recover this saved data. See the following section.
4.10.19 Load from ash
The Load From Flash screen is displayed below:
LOAD FROM FLASH
All Settings will be
Overwritten!
PROCEED: $ (Y/N)
Press YES/7 and ENTER to overwrite all of the current user setup information with the data that was
previously saved to the ash memory. Loading from ash memory will load all setup information that was saved
to the Flash PROM chip within the controller.
4.10.20 Load default
The Load Default screen is displayed below:
LOAD DEFAULTS
Settings will be
Overwritten by the
defaults! PROCEED:$(Y/N)
Press YES/7 and ENTER to overwrite all of the current user setup information with the factory defaults.
4.10.21 Display menu
Paths: Status Screens / Set up(3) / System(4) / Display(13)
The DISPLAY menu has been shown below:
Delay to Display
Status # m
Rate ##s Exit $(Y/N)
Press the next ( ) key to go to the next screen. The display now shows:
<Backlight
Off Tmr: ###m
Exit $ (Y/N)
To edit the values, press the NO/0 key and ENTER key. Modify the values as desired.
▲