Owner manual

AQUAFORCE Installation, Operation, and Maintenance
24
Password Menu Items (continued)
Menu Item Variable Default Range Field
Value
Verify VERIFY THE PASSWORD
PASSWD >_ _ _ _ _ _<
After entering data in password denition screen this
screen requires the user to conrm the requested
password. If the conrmed number does not agree with
the rst number the Enter New Password screen is
repeated to allow the user to get both input screens
to agree.
4.10.13 I/O setup menu
Paths: Status Screens / Set up(3) / System(4) / IO Setup(9)
See the following table for all I/O Setup menu items.
NOTE: The total available number of I/O to be congured depends on the system setup. Complete all previous
setup screens, specically pumps and sensors prior to completing the following.
I/O Setup Menu Items
Menu Item Variable Default Range Field
Value
DO Total Avail. DO = # N/A 0-99
This screen can not be modied. It is here to advise the
user of how many digital outputs can be customized
* DO No: #### N/A 0-999
Enter the output to be congured as it appears on the
terminal number.
* Code: ### 0 0-255
Enter the code to dene the desired functionality of the
output. Valid codes are dened in the Appendix of this
manual.
AO Total Avail. AO = # N/A 0-99
This screen can not be modied. It is here to advise the
user of how many analog outputs can be customized
* Code: ### 0 0-255
Enter the code to dene the desired functionality of the
output. Valid codes are dened in the Appendix of
this manual.
NOTE: If a programming error happens, an error message is displayed. An error may be due to reprogramming
an input that is currently used by the system or inputting an undened code number.
4.10.14 Communication Menu
Paths: Status Screens / Set up(3) / System(4) / Communication(10)
The MODBUS screen is displayed below:
Modbus
9600, 8, 1, 1, N RTU
Node: # Al Ovrd: $
OK: $(Y/N)
The rst line conrms setup for Modbus protocol. The second line denes the 9600 bps baud rate, 1 stop bit, 1
start bits, and no parity. The third line requires user input. Obtain the node number from the manufacturer that
supplied the device that will communicate with the Controller.
Installation