Use and Care Manual

WARRANTY RULES AND PRECAUTIONS

CARBON MONOXIDE PRECAUTIONS

FIRE AND EXPLOSION PRECAUTIONS

CHEMICAL PRECAUTIONS

Insert the shank of the Auger (33a) fully upward into the Transmission Shaft (15a). Align the mounting holes

in the Auger and Transmission Shaft. Then secure the Auger to the Auger Drill using the Pin (34a) and Safety

Pin (35a).

ASSEMBLY

1. Fill the fuel tank: To obtain the proper 25:1 fuel mix, combine 25 parts unleaded

gasoline (89+ octane) with 1 part 2-cycle oil in the provide Fuel Mix Container (36a).

Cover and shake to thoroughly mix before each fueling.

PRE-START INSTRUCTIONS

NOTE: Mix only enough fuel for a few days work. The maximum storage time of mixed

fuel is three months.

2. Once the proper fuel mix is obtained, removed the Fuel Cap (93). Fill the Fuel Tank (89) approximately ¾

full with the fuel mix. Then replace the Fuel Cap. See Figure B.

WARNING: Do not attempt to ll the Fuel Tank (89) when the engine is running or hot to the touch.

IMPORTANT: Your warranty is voided if you do not operate the Auger Drill with the proper amount of SAE

80-90 gear oil in its Gearbox (8a). DO NOT run the Auger Drill with low or no gear oil. Running the unit in

this manner can permanently damage the unit.

FILL THE GEARBOX

1. Remove the Oil Fill Plug (20a) and carefully ll (approximately 8-1/2 ounces) the Gearbox (8a) then

replace the Oil Fill Plug and tighten securely. See Figure B.

NOTE: DO NOT use dirty, used or otherwise contaminated Gear Oil. Damage may occur to the internal

mechanisms of the Gearbox.

ASSEMBLY AND OPERATION