Installation Guide
SAFETY WARNINGS INSTALLATION AND MAINTENANCE
1 2
INSTALLATION & OPERATION
IMPORTANT: Always make sure the input power is completely disconnected and all pool equipment
is shut off before attempting any service procedures. All service should be performed by a qualied
professional.
Remove the old Cell from the plumbing by loosening the threaded collars on both ends of the Cell.
Disconnect the Cell Cord from the control panel.
Inspect the O-Rings on the plumbing unions. If damaged or worn, replace before installing the new
Cell.
Position the new series Replacement Cell between the plumbing unions. Tighten the two threaded
collars by hand for a water-tight seal, do not over-tighten. Plug the Cell Cord into the control panel.
Once power is restored to the control panel (concurrently with the pump and lter), the system can
now be operated as instructed in the original manufacturer’s product manual.
MAINTENANCE
The replacement Cell operates in the same way as your original Cell. As with your prior system, it may
occasionally be necessary to remove the mineral deposits which can form inside. Cleaning frequency
is entirely dependent on your pool’s water chemistry, which depending on environment and chemicals
added, can change to become more or less scale forming. Follow the cleaning instructions in the
original manufacturer’s product manual.