Instructions / Assembly

Before you beginBefore you begin

Pre-Installation Checklist

Spread out parts on groundSpread out parts on ground

STEP 1: Mount Control BoxSTEP 1: Mount Control Box

OverviewOverview

1.For 70184, make sure the pool is not bigger than 12000 gallon; for 70183, the pool is

no bigger than 18000 gallon.

2.You have acquired an CELL salt cell(sold separately)

3.There is at least 10 inches of straight pipe in the return piping after all installed

equipment and the pipe is at least 2 inches off of the ground) to install the Cell Vessel

4.The control Box will be mounted within 6.5 feet of a GFCI outlet

5.The control Box will be mounted within 15 feet of the installed Cell Vessel

6.The control Box will be installed at least 10 feet away from the pool

7. Pool plumbing is 1.5”

8. You have a saw suitable for cutting PVC

9.You have tools for mounting the Control Box (drill, drill bits, screwdriver)

10.You have a permanent marker to mark the PVC pipe

11.You have balanced your pool chemistry and have 3200ppm salt in you pool (see Chemistry

Quick Start Guide)

Installation Preparation

1.Read this entire Quick Start Guide

2.Remove power to filter pump

3.Dram water from pool piping

4.Verify that all parts are included in the box

5.You are wearing safety glasses and have read the safety precautions in the owner’manual

PVC ( If black polyethylene pipe is used ,see manual)

Note: If it's necessary to install the salt water chlorinator

vertically, please install according to the indicated arrow

(outlet position must be higher than inlet), never install

in wrong direction, otherwise the flow switch assembly

may disabled.

Mount the Control Box to a wall or post within 6.5 feet of a GFCI outlet, making

sure that the cord will reach. The Control Box will also have to be mounted within

15 feet of the Cell Vessel as shown in the Overview.

Use the include Mounting Template to help locate the mounting holes and fasten

the Control Box to the intended surface.

Secure Mounting template to

desired mounting location and

drill mounting holes

Screw in bottom fasteners securelyFix the controller box on the wall,

put the gaskets on the screws, and

fasten the screws into the holes.

Electronic Chlorine GeneratorInstallation Quick Start

Turn Over

PAGE 1
Electronic Chlorine GeneratorInstallation Quick Start Before you begin Overview Pre-Installation Checklist 1.For 70184, make sure the pool is not bigger than 12000 gallon; for 70183, the pool is no bigger than 18000 gallon. 2.You have acquired an CELL salt cell(sold separately) 3.There is at least 10 inches of straight pipe in the return piping after all installed equipment and the pipe is at least 2 inches off of the ground) to install the Cell Vessel 4.The control Box will be mounted within 6.
PAGE 2
STEP2:determine 2:determinewhere whereCell CellVessel Vesselwill willbe beinstalled installed STEP s return piping The Cell Vessel must be the very last component installed in the pool’ before the water returns back to the pool. It can be installed vertically or horizontally and requires approximately 10 inches of straight pipe at the installation location. Use the included Cutting Template to aid in marking and cutting the pipe.