Installation Guide

Step 4: Making Your Custon Cut
* Measuring Your Custom Cut: Your custom section is the
one that doesn't fit. The first step is to measure your
custom cut. Note whether you will be cutting from the right
side or the left side of the full section. See Fig.21 below
PRO NOTE: When measuring for a custom cut or cutting fence
you should always remember that the moldings face out away
from the pool. When measuring your cut section always face
the pool.
Measure the outside centerline fo the odd panel. Next
count the number of poles in the odd section and double
check whether it is a cut to the right or a cut to the left.
See Fig.22-23.
If you noticed in Fig.22 our example custom cut is a 4 pole and then a cut
to the right. Let's say this cut is a
4 pole 23 1/2'' to the right. When you measure make sure
you are measuring between the two centerlines of either
hole. Fig.23 illustrates the scribe lines but when you are
ready to measure for your cut you will be dealing with
drilled holes in the concrete and there will be no scribe
lines draw across the holes. The scribe lines in the figure
are ro remind you that your cut happens to fall ona turn,
you must remember that your center line turns as well.
*Make Your Cut: Now you have the measurement and
you can make the cut. Roll out your full section (screws
facing up)in front of the custom cut area and face the pool.
Looking at the full saction count the poles over until you
reach the panel that needs to be cut. Our example cut is a
4 pole 23 1/2'' to the right. See Fig.24 below.