Installation Guide

* Custom Cut:Is when the last piece is less than the
36''template. Marking your custom cut is just like marking
out a full 3 foot panel only the last panel is usually shorter
than 3 feet. This is the custom cut you will make later. This
section is the last one marked out, usually in the back of
the pool, where you will not notice it. The last piece will
most likely have fewer poles in it. This example depicts a
two pole cut.
* Lay Back Holes:are needed for the manual opening
and are used to place the end poles of section into
when using the pool. See Fig.9 &10
Step 2: Understanding How to Drill
* Angle & Level Hole: Before drilling you need to survey all
the holes and mark the direction in which the holes will be
drilled, should it be a Light Lean Angle, Heavy Lean Angle or
a Level Hole? Should the pole lean toward the pool or away
from the pool or be level? See diagram below. Mark an
arrow on the deck surface to avoid making a mistake.
Angles are needed to ensure proper tension and aesthetics.
Fig.12 shows a Light Lean Away from the pool. Fig.13
shows a Heavy Lean toward the pool. Level holes are drilled
perpendicular to the deck surface or no lean at all. See
Fig.14
* Understand the Angle to be Frilled: See Fig.15a-Fig.17