Installation Guide

* Then place the template over 1R and mark your second hole for that
section(Fig.5a).
* Now repeat until pole 5th of the section Fig. 6-7a
* Mark your last hole for that section,(hole 5)Fig.7a.
* Then use the double hole on the template and align it
over the 5th hole you marked Fig.7b and mark the first
hole of the next connecting section to the
right,(hole).Repeat these steps on the both sides of the
pool until you reach the section that will be the cut section.
** See Fig.8 on the next page
for the full lay out example.