Installation Guide

Hold your tape measure on the OUTSIDE OF THE MOLDING
as shown in FIg.25. and make a mark on the border at the
top and bottom of the fence with a marker.
Using your scissord you can proceed to cut the mesh.
Sliding your ruler up against the molding to make sure
you are cutting at exactly the measurement you took. See
Fig.26 Make sure the mesh us tight and remove the extra
pole from the extra piece.
Your cut has been made and you now have to attach the
border material included.Place mesh between bothflaps
of the border and slide the strip of border down the mesh
then staple it on. Staples should be
1/4'' off line of mesh in border. See Fig.27-28. Make
sure the mesh fully inserted inside the border material
included.