How Solar Panel Works Using your pool pump, water is automatically pumped through the solar collectors. The water is then heated by the sun as it moves through the collectors. The heated water is returned back to the pool, through your return lines. You c a n enjoy your own heated pool with no fuel costs. PERFORMANCE The design of the solar panel is so good that it could reach the most heating area, longest heating time and the best heating affection.
PLEASE READ THIS MANUAL CAREFULLY. YOUR ENJOYMENT OF YOUR SOLAR HEATED POOL AND YOUR WARRANTY ARE AFFECTED BY HOW YOUR SOLAR HEATING SYSTEM IS INSTALLED CAUTION: a) solar collectors are often installed on the roofs of buildings. Unless you are very familiar with working on roofs and have the proper ladders and safety equipment for such work, you should hire someone with the necessary experience to do the installation.
STANDARD COMPONENTS ITEM NO DESCRIPTION 5 QTY 1. 2. O RING 2 SILICON LUBRICANT 1 3. 1-1/2” S.S. CLAMPS 2 4. 1-3/4” S.S. CLAMPS 2 5. SMALL ELBOW 1 6.
CAUTION: Unless you are familiar with working on roofs and have the proper ladders and safety equipment for such work, you should hire someone with the necessary experience to do the installation. Failure to observe safe practices on a roof WARNING: DO NOT WALK ON THE SOLAR COLLECTORS ROOF INSTALLATIONS: It is suggested that you use rigid PVC pipe for roof installations. The collector should slope slightly toward the inlet point (where the water enters the collectors) to allow for drainage.
If your pump is greater than 0.5HP, please use the diverter kit (see page component kit) to shunt the flow COOL WARM SYSTEM LAYOUT If your systems use the pump less than 0.
installation for 3pcs panel with pump 0.5HP or less than 0.5HP COOL WARM SYSTEM LAYOUT When you use the pump greater than 0.5HP, please refer the following connection way.
Operation 1. The collectors should feel cool to the touch when the sun is shinning on them and water is passing through. This means that the heat is being transferred to the water. 2. The water returning to your pool will be a few degrees (3-5degrees) warmer than the pool itself. This is the most efficient way to heat a large body of water like a pool. Keep circulating the water, which adds a few degrees each pass. 3.
COLLECTOR REPAIR IF A COLLECTOR DEVELOPS A LEAK If a leak develops for any other reason, you may use the repair method shown. The collectors are not warranted against freeze damage. SOLAR COLLECTOR REPAIR This method allows for an easy and permanent, on-site repair of a collector by isolating the leading riser tube. Referring to the figure at the right, locate the tube to be isolated. (End tube has been shown for clarity).
9
