Instructions / Assembly
FILTER RE-ASSEMBLY INSTRUCTIONS
WARNING
RE-INSTALLING
1. Lubricate outlet elbow O-rings
Replace filter element cluster into filter tank, carefully
fitting top collector manifold outlet over outlet elbow O-ring.
CLEAN SEAL RING AND SEAL SURFACE
clean seal of all dirt and debris. (Fig 4) Do not use a solvent.
components.
WARNING
This product should be installed and serviced only by a
BODY AND CLAMP RE-ASSEMBLY
1. Place the metal reinforced seal on lower
body in a position which allows all
operation and safety labels to be clearly
body to seat the seal. (Fig 7)
3. Insert clamp bolt through the clamp ends and thread the clamp nut onto clamp bolt with rounded end of the
nut (Fig 8) towards the ends of the clamp.
clamp nut to clamp bolt to 150 inch-lbs. (Fig 9)
DO NOT HIT OR STRIKE CLAMP WITH HAMMER OR METAL TOOLS.
VACUUMING POOL
Backwash filter after vacuuming, if required.
DRAIN
PLUG
LOWER
FILTER
BODY
ALIGN
LABELS
Figure 7
Clamp bolt
Rounded end of nut
Figure 8
using a
Figure 9