Use and Care Manual

INSTALLATION

POWER CONNECTION

Be sure to check whether used voltage is corresponding to the required voltage indicated on the

nameplate label. The voltage for the motor should not exceed 10% or below the requirement on the

requirement on the nameplate label. If too much voltage is applied, the motor will overheat and lead

to overload trip and shorten the life of the component. All connections must be applied by a qualied

technician. All wiring must comply with local and national and local laws. The leakage circuit breaker

must be congured to avoid electric shock when deterioration of the insulation occurs due to product

age.

CONTROL PANEL INSTRUCTION

TIMER INITIATION

NOTE: Make sure the power supply is off.

1. Unscrew the four screws on the lid of the terminal box and remove the lid.

2. Remove the battery.

3. Remove the rubber lm on the surface of the battery.

4. Replace the battery.

5. Replace the lid on the terminal box and re-tighten the four screws.

SWIMMING POOL AND SPA PUMP

MADE IN CHINA

MODEL : 72717

VOLTS : 115V

AMPS : 3.6A

QMAX : 150L/min (44GPM)

MAXIMUM WATER TEMPERATURE: 40 °C

MOTOR OVERHEATING PROTECTION DEVICE

Hz : 60

HMAX : 10M

TIMES

ON/OFF

2h 4h 6h 8h 10h 12h 16h 24h

TIMER

INDICATOR

ON/OFF

BUTTON

TIMER

BUTTON

SINGLE CYCLE

INDICATOR

BUTTON CONTROL INSTRUCTION