Use and Care Manual

INSTALLATION

5. Connect the sand tank to the pump with hose and hose adapters.

INSTALLATION NOTES:

Make sure the lter has worked under work pressure and using a pressure control valve when the

system is using a booster pump.

If the pump position is higher than the water level, it requires installing an isolation valve. It can stop

the water return back when doing the general inspection.

If the pump position is higher than the water level, it requires installation of the back water control

valve.

Reduce the connection adapters and hose connection, bending as little as possible. Decreasing the

water ow scrub can reach the maximum effectiveness

Ensure solvents are not excessively applied to the tting as this can run onto the O-ring and create

sealing issues.

Do not over tighten ttings or adapters.

HOW TO USE:

1. Inspect all connections have been made and are secure.

2. Depress the top mount valve handle and rotate to BACKWASH position.

3. Prime and start pump according to the pump instructions.

NOTE

All suction and discharge valves must be opened when starting the system. Failure to do so can

cause severe personal injury. Make sure the lter vessel are full. Fill the water before start-up the

pump. Failure to do so can cause damage to the pump.

4. Once water ows steadily out of the waste line, run the pump for at least 2 minutes. The initial back-

washing of the lter is recommended to remove any impurities of ne sand.

5. Turn the pump off and set the valve to RINSE position. Start the pump and operate until water in the

sight window is clear. Turn the pump off and set the valve to the FILTER position and restart the pump.

Your lter is now operating in the normal lter mode, ltering particles from the pool water.