Use and Care Manual

5
1. Pump needs screw and cover to install on the lter drain.
2. Press and turn the sand tank to mount it to the sand lter support with correct direction, drain plug
on the outside (see below)
3. Insert the tube with diffuser body inside the tank as above picture shows, then place the funnel on
the tank’s mouth and out the quartz sand into the tank. A 12” sand lter requires about 19kg of sand to
ll the tank, a 14” sand ller needs about 27kg of sand to ll the tank.
4. Remove the funnel and make sure the tank’s neck is clean. Put the O-ring on the valve and use
clamp to x the valve with the tank. Pump port valve direction needs to face pump’s out-port.
INSTALLATION