Use and Care Manual
4
IMPORTANT SAFETY INFORMATION / INSTALLATION
Always turn pump off before changing valve positions. Changing valve positions while the pump
is running can damage the control valve, which may cause serious injury or property damage.
Allowing water to freeze in the system will damage the system and cause potential water damage/
ooding and potential property damage.
SAND FILTRATION WORKING PRINCIPLE
Incoming water from the piping system is automatically directed by the multi-port valve to the top of the
lter bed. As the water is pumped through the lter sand, dirt and debris are trapped by the lter bed, and
ltered out. The lter water is returned from the bottom of the lter tank., through the multi-port and back
through the piping system .
PREPARATION BEFORE INSTALLATION
1. Position the lter as close to the swimming pool / spa as possible.
2. The lter should be placed on a level, concrete slab, rm ground or equivalent.
3. Position the lter near piping so that it is convenient for operating and servicing.
4. Ensure that the compliance label is facing front to allow easy identication.
INSTALLATION
1. Pump needs screw and cover to install on the lter drain.
2. Press and turn the sand tank to mount it to the sand lter support with correct direction, drain plug on
the outside (see below)