Manualshelf

Instructions / Assembly

ManualsBrandsXtremepowerUS ManualsOutdoors12 in. Sand Filter Above-Ground with 0.25 HP Pump Power and Pool Pump 6-Way Valve Media Filter Included
12345678
2
SAFETY INFORMATION
1. The sand filters are
designed to work with water at temperature>than 0℃ and <than 45℃.The filter
should never be operated outside of these temperatures or damage may occur.
2. The installation should be carried out in accordance to the safety instructions of swimming pools and the
specific instructions for each facility.
3. The user should make sure that the installation is carried out by qualified authorized persons and that
these persons have first carefully read the following instructions. Incorrectly installed equipment may fail,
causing severe injury or property damage.
4. The operating safety of the filter is only guaranteed if the installation and operation instructions are
correctly followed.
5. To reduce the risk of injury, do not permit children to use this product.
6. Chemical spills and fumes can weaken Swimming Pool/ Spa. Corrosion can cause filters and other
equipment to fail, resulting in severe injury or property damage. Do not store pool chemicals near your
equipment.
7. Any modification of the filter requires the prior consent from the supplier’s original replacement parts and
accessories authorized by the manufacturer ensure a high level of safety. The supplier assumes no liability
for the damage and injuries caused by unauthorized replacement parts and accessories.
8. In the event of defective operation or fault, contact the supplier or its nearest authorized service
agent.
Sand Filtration system working principle
Incoming water from the piping system is automatically directed by the Multi-port Valve to the top of the filter
bed. As the water is pumped through the filter sand, dirt and debris are trapped by the filter bed, and filtered
out. The filtered water is returned from the bottom of the filter tank, through the Multi-port Valve and back
through the piping system.
Preparation before installation
1. Position the filter as close to the
Swimming Pool/ Spa as possible.
2. The filter should be placed on a level concrete slab, very firm ground, or equivalent. Ensure that the ground
will not subside, preventing any strain from the attached plumbing.
3. Position the filter under consideration of the piping connections, so that it is convenient for operating
and servicing.
4. Ensure that the compliance label is facing the front to allow easy identification in the case of service
difficulties.
SAFETY IN
FORMATION