Use and Care Manual

-1-
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
These instructions are for
correct installation, and optimum performance of the Bath pumps, so
they should be read carefully. These are single-stage centrifugal pumps designed to
operate with compact hydro-massage equipment, They are equipped with a total-emptying
system to prevent the discharge of residual liquid in each stopping.
These units are designed to operate with clean water at a maximum water temperature of
50
°
C.
Built of top quality materials, they are subjected to strict hydraulic and electrical controls and are
carefully verified. Correct installation is ensured by following these instructions and those of
the wiring diagram; otherwise, over loads may be produced in the motor. We decline
responsibility for any damage caused by not following these instructions.