Replacement Part List

4
ASSEMBLY AND OPERATION
UNPACKING
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken,
please call XtremePowerUS at 1-909.628.0880 to obtain a replacement part.
PLEASE NOTE: The Log Splitter is heavy; use care and proper lifting techniques when move the Log
Splitter.
ASSEMBLY
To assemble, insert one Jack Handle (3) into each of the sockets on the Ram (9). See Figure 1, above.
The Splitting Operation - Additional Safety Instructions:
1. Hold the bark side of logs when loading or positioning, never the ends. Never place your hands or any
body parts between a log and any part of the Log Splitter.
2. NEVER load or unload logs while the Ram (9) is moving.
3. DO NOT pile logs to be split in a place that will make you reach across the Log Splitter in order to load
4. Log ends that are not cut square can slide out while splitting and cause a safety hazard or cause
excessive force to Log Splitter components. Use a chainsaw (not included) to cut logs square on each end
before attempting to split them.
5. NEVER attempt to split more than one log at a time. A piece of log can unexpectedly be thrown from the
machine, causing severe personal injury.
6. DO NOT use the Log Splitter to split logs across the grain. Doing so will damage the Log Splitter and
could also cause pieces of log to be thrown, injuring the operator or bystanders.
NOTE: Note: Many accidents occur when there is more than one person involved in loading and operating
the Log Splitter. Only one person should operate at a time. If a second person is assisting in loading logs,
NEVER allow an assistant to hold the log in place while the operator pulls on the Jack Handles.