Replacement Part List

PRE-OPERATION INSPECTION

OPERATION

Generator OIL: a key factor in deciding the generator’s performance. Do not apply generator oil with additives

or 2-stroke gasoline oil, as they haven’t enough lubrication, which may shorten the generator’s service life.

1. Before adding fuel, make sure the generator is on a level, at surface equipment.

Generator oil recommended: SAE10W-30. As viscosity varies

with regions and temperatures, so the Lubricant has to be

selected in accordance with our recommendation.

2. Clean the top of the Dipstick and the area around it. Remove

the Dipstick and wipe it off with a clean, lint free rag.

3. Reinsert the Dipstick without threading it in and remove it to

check the oil level. The oil level should be up to the full level.

4. If the oil level is at or below the low mark add the appropriate

type of oil until the oil level is at the proper level. SAE 10W-30

oil is recommended for general use.

5. Thread the dipstick back in.

NOTICE: DO NOT run the generator with

too little oil. Generator will shut off if

generator oil level is too low.

BATTERY (only for 2GF-4, 2.5GF-4, 2.8GF-7: Check and

make sure the electrolyte level of each battery is between

the upper and lower lever markers.

1: Upper level marker 1: Lower level marker

AIR FILTER ELEMENT MAINTENANCE:

1. Wipe off the air cleaner cover. The air cleaner cover is held in place by clamps. Remove the clamps and

the cover.

2. Remove the air lter element.

3. Cleaning: A. There are two foam lter elements. Wash them in warm water and mild liquid soap several

times. Rinse. Squeeze out excess water and allow it to dry completely. B. Soak the lter in lightweight oil

briey, then squeeze out the excess oil.

4. Install the new lter or the cleaned lter. Secure the Air Cleaner Cover before use. Gasket-style: Finger-

tighten until the gasket contacts the cylinder head, then about 1/2-2/3 turn more. Non-gasket-style: Finger-

tighten until the plug contacts the head, then about 1/16 turn more.

5. Apply dielectric spark plug boot protector (not included) to the end of the spark plug and reattach the wire

securely.