Instructions / Assembly

MINI TRACKED DUMPER
15
GB
Lubrication
General Lubrication
Lightly lubricate all moving parts of the
machine at end of the season or every 25
operating hours.
Gearbox Lubrication
The gearbox is pre-lubricated and sealed
at the factory. Unless there is evidence of
leakage or service has been performed on the
gearbox, no additional lubricate should be
required until 50 hours use.
After first 50 hours use, change all the gear oil.
Capacity is 1.5L.
For future use, check the oil level after every
50 hours of use. If you remove the oil level
plug and no oil flows out, please add oil and
then screw the oil level plug.
Gear oil GL-5 or GL-6, SAE80W-90 is
recommended. Do not use synthetic oil.
When replacing gear oil, the engine must be
stopped and still warm. Unscrew the filter
cap and the drain plug. When oil is drained,
replace the drain plug, fill up with fresh oil, and
then replace the filter cap.
Remove all the screws and washers from both
belt covers and take off the covers.
Dismount the two M10X25 bolts and washers
and remove the pump with flange.
Dismount the three M6x12 screws and washers
and remove the hydraulic valve and its
mounting plate.
Turn the gearbox pulley and pull out the drive
belt.
M8×16 (×2)
M8×20 (×1)
M6×12 (×2)
Belt Cover
M6×12 (×2)
M6×12 (×1)
Drive Belt
Pump with Flange
M10×25 (×2)
Oil Outlet
09737UK00M100_更新回收处理标志.indd 15 2019/9/4 11:01:44