Instructions / Assembly

MINI TRACKED DUMPER
13
GB
Avoid sharp turns and frequent changes of
direction while driving on rough, hard terrains
full of sharp, uneven points with a high degree
of friction.
Even though the unit has rubber tracks,
remember to be careful when working in
adverse weather conditions (ice, heavy rain
and snow) or on types of ground that could
make the mini tracked dumper unstable.
Please note that as this is a tracked vehicle, it is
subject to a considerable pitching movement
when passing over bumps, holes and steps.
When the clutch control lever is released, the
machine will stop and brake automatically.
If the machine is stopped on a steep slope, a
wedge should be placed against one of the
tracks.
Idle Speed
Set the throttle control lever to the SLOW
position to reduce stress on the engine when
work is not being performed. Lowering the
engine speed will help extend the life of the
engine, as well as conserve fuel and reduce
noise level.
Stop Engine
To stop the engine in an emergency, simply
turn the engine switch to the OFF position.
Under normal conditions, use the following
procedure:
1. Move the throttle lever to the SLOW (
)
position.
2. Let the engine idle for one or two minutes.
3. Turn the engine switch to the OFF position.
4. Turn the fuel valve lever to the OFF (
)
position.
Do not move the choke control to
CLOSE to stop the engine. Backfire
or engine damage may occur.
Sudden stopping at a high speed under
a heavy load is not recommended.
Engine damage may result.
Adjusting Clutch
When the clutch begins to show wear, the
handle reach will become wider, making it
more difficult to reach. Follow these steps
to return the clutch lever back to its original
position.
1. Loosen the jam nut by turning it counter
clockwise with 10 mm wrench.
2. Tighten or loosen the cable by turning the
cable adjustment nut clockwise or counter
clockwise with 10 mm wrench until you have
reached your required tightness.
MAINTENANCE
Maintaining your mini tracked dumper will
ensure long life to the machine and its
components.
Preventive Maintenance
1. Turn off the engine and disengage all
command levers. The engine must be cool.
2. Keep the engine’s throttle lever in its SLOW
position and remove the spark plug wire
from the spark plug and secure.
3. Inspect the general condition of the mini
tracked dumper. Check for loose screws,
misalignment or binding of moving parts,
cracked or broken parts, and any other
condition that may affect its safe operation.
4. Use a soft brush, vacuum or compressed
air to remove all contaminants from the
machine. Then use high quality light oil to
lubricate all moving parts.
5. Replace the spark plug wire.
Never use a “pressure washer” to
clean your unit. Water can penetrate
tight areas of the machine and its
transmission case and cause damage
to spindles, gears, bearings, or the
engine. The use of pressure washers
will result in shortened life and
reduce serviceability.
09737UK00M100_更新回收处理标志.indd 13 2019/9/4 11:01:34