Instructions / Assembly

MINI TRACKED DUMPER
11
GB
Operation
Never use choke to stop engine.
No oil in the engine originally, but
a bottle of engine oil is in scope
of delivery. Don’t start the engine
before adding oil.
Gasoline is highly flammable and
explosive. You can be burned or
seriously injured when handling fuel.
Use extreme care when handling
gasoline.
Fill the fuel tank outdoors, never
indoors. Gasoline vapors can ignite
if they collect inside an enclosure.
Explosion can result.
DO NOT OVERFILL. Check engine
oil level daily and add as needed.
Engine On/Off Switch
The engine switch has two positions. OFF -
engine will not start or run. ON - engine will
start and run.
Recoil Starter Handle
The Recoil Starter Handle is used to start the
engine.
Fuel Shut-Off Valve
The fuel shut – off has two position.
CLOSED (
) - use this position to service,
transport, or store the unit.
OPEN (
) - use this position to run the unit.
Throttle Control
The throttle control regulates the speed of the
engine, and moves between FAST
, SLOW
, and STOP positions.
The throttle control will shut off the engine
when it is moved to the STOP position.
Choke Control
The choke control is used to choke the
carburetor and assist in starting the engine.
The choke control slides between the CHOKE
CLOSED
and CHOKE OPEN positions.
Clutch Control Lever
Squeeze the control lever, clutch engaged.
Release the lever, clutch disengaged.
High / Low Speed
Shifting Handle
High speed mode is
preferred in good driving
conditions such as good
weather and stable
ground. Otherwise, use
low speed mode.
Pull the speed shifting
handle backward to
enable high speed mode
and push it forward to
switch to low speed
mode.
1. Make sure the mini tracked dumper is on a
flat, level surface.
1. The engine must be off and allowed to cool
at least two minutes before adding fuel.
2. Remove the fuel filler cap and fill the tank.
(See engine manual for fuel capacity, fuel
recommendation, and location of fuel cap.)
Add Oil To Engine
Add Oil To Engine
3. Using a funnel, add oil up to the FULL mark
on the dipstick. (See engine manual for oil
capacity, oil recommendation, and location
of fill cap.)
2. Remove the oil fill
cap/dipstick to add
oil.
CLOSEDOPEN
3 2 1
QUICK
CHANGE
3 2 1
09737UK00M100_更新回收处理标志.indd 11 2019/9/4 11:01:31