Instructions / Assembly
MAINTENANCE
The belt is not separated completely, tensioning position please V belt adjustment. Removed bolt belt wheel
cover, belt tensioner in the parking position does not contact the V belt, do not rotate in [walk] and position.
Then tighten the bolts, tighten the nuts.
Checking and Adjusting the Brakes:
1. Take off the plastic cover
2. Put the walking clutch rod to Stop the machine position
3. Make sure the spring length A is between 185-190mm,
adjust if there is any inappropriate.
4. Put on the plastic cover
1. Take off the plastic cover
2. Loosen the nut
3. Put clutch rod to Stop the machine position.
4. Adjust nut 1 to make sure the spring length A is between
185-190mm.
5. Tighten the nut 1, then loosen nut 2
6. Put walking clutch rod to Walking position, and adjust adjusting nut 2 to cancel brake condition.
7. Tighten nut 2 then put the plastic cover back on.
Turning Clutch Adjustment:
1. Take the cargo container, and x it with the
supporting frame.
2. Adjust the adjusting nut, and make turning
clutch handle to have 1-5mm empty space.
3. Put off the cargo container.
ENGINE MAINTENANCE:
1. Check oil level before each use and after 8 hours of operation.
2. Change oil after rst 5-8 hours of operation.
Change oil while engine is warm. Rell with new oil of
recommended grade.
3. Check spark plug yearly or every 100 hours of
operation
4. Service the air cleaner.
5. Keep the engine and parts clean
6. Check the engine and equipment often for loose
nuts and bolts.
6