Instructions / Assembly

4
OPERATION
STARTING THE ENGINE:
FOLLOW THE PROCEDURE BELOW FOR COLD STARTS:
1. Turn choke lever on the engine to the CLOSED position.
2. Set the throttle lever on the handlebar at halfway position
3. Turn the engine switch on.
4. Pull the starting rope slowly several times to allow the gasoline to ow
into the engine’s carburetor. Then hold the start handle rmly and pull
rope out a short distance until you feel some resistance. Then pull the
rope smoothly and briskly, and allow rope to return gently. Do not let the
rope snap back. If necessary, pull the rope several times until the engine
starts.
5. Allow the engine to run for several seconds to warm up. Then, gradually
move choke lever to “OPEN” position
Restarting a warm engine does not require use of the choke, so follow the
same steps above with the choke lever set to the OPEN position.
STOPPING THE ENGINE:
To stop the engine in an emergency, simply turn the engine switch to the OFF position. Under normal conditions,
use the following procedure.
1. Move the throttle lever to the SLOW position.
2. Let the engine idle for one-two minutes.
3. Turn the engine switch to the OFF position.
4. Turn the fuel valve lever to the OFF position
CAUTION: DO NOT move the choke control to stop the engine. This may result in engine backre or
damage to the engine may occur.
After engine warms up, pull throttle lever to accelerate engine speed. Engage the required gear and slowly
squeeze the clutch control lever. If the gear does not engage right away, slowly release the clutch lever and
try again.
STOPPING THE ENGINE:
CHANGING DIRECTIONS:
1. To turn left, pull the left steering lever upwards.
2. To turn right, pull the right steering lever upwards.
The sensitivity of the steering increases in proportion to the speed of the machine and that with an empty
machine, a light pressure on the lever is all that is needed to turn. When the machine is loaded, more pressure
is required. It is recommended that the operator practice driving the Power Cart with the dumper empty to
become familiar with the equipment’s operation before attempting to move a load.
LOADING AND UNLOADING:
1. Position the Power Cart into the desired position for dumping the load.
2. Turn off the engine and put the clutch lever into the STOP position.
3. Pull the tipping handle up to release the dump box’s locking device and raise the dump box.
4. Raise the dump box manually to dump the load.
5. Pull the tipping handle down to its original position. When the dump box is lowered, the locking mechanism
operates, locking the dump box.