Replacement Part List

Service Interval: Every 25 Hours, or As Necessary. The shredding hammers of this unit can be rotated

to provide a new cutting surface as required. The triangular hammers can be rotated twice, then ipped

over for a total of 6 sharp cutting surfaces. The J-hammers can be ipped over once. To inspect the

shredding hammers:

1. Disconnect the spark plug wire and secure it away from the spark plug. SEE FIGURE 12

2. Remove the small circular access panel (B) from the back of the shredder housing. SEE FIGURE 9

3. Inspect the cutting edges of the triangular hammers (A) and J-hammers (A). SEE FIGURES 9 AND 10

To rotate or replace the shredding hammers, see the Troubleshooting and Repair section.

INSPECT / ROTATE SHREDDING HAMMERS

Service Interval: Before each use and every 100 hours. The engine requires air ow to cool itself and

for combustion. Before each use, clean any debris from the unit especially from around the air shroud

intake, air lter, and mufer. Every 100 hours, remove the engine air shroud and clean out any debris from

the engine cooling nsand J-hammers (A).

CLEAN DEBRIS FROM ENGINE & CHIPPER

Service Interval: Every 25 Hours, or As Necessary. The

shredding hammers of this unit can be rotated to provide

a new cutting surface as required. The triangular hammers

can be rotated twice, then ipped over for a total of 6 sharp

cutting surfaces. The J-hammers can be ipped over once.

To inspect the shredding hammers:

1. Disconnect the spark plug wire and secure it away from

the spark plug.

2. Remove the small circular access panel (B) from the back

of the shredder housing.

3. Inspect the cutting edges of the triangular hammers (A)

and J-hammers

CLEAN DEBRIS FROM ENGINE & CHIPPER

MAITENANCE