Use and Care Manual

OPERATION

To adjust the angle of the cut, loosen the Angle Locking

Lever (12), then slide to the degree of tilt you require and

tighten to secure.

ANGLE ADJUSTMENT

IMPORTANT: Once you have adjusted the

angle, ensure you have securely re-tightened

the Angle Locking Lever (12) before using the

tool in order to avoid damage to the tool and injury to the

user.

To achieve the required depth of cut, loosen the Depth

Locking Lever (10) and slide to the desired depth using

the Depth Adjustment Scale (17) as a guide. Once the

desired depth has been set, re-tighten the Depth Locking

Lever (10) and make sure it is secure.

DEPTH ADJUSTMENT

IMPORTANT: Before using the saw, rst ensure all screws and bolts are tightened and that all the correct

adjustments have been made.

POWERING ON/OFF

Plug the saw into a suitable outlet. To power on the

saw, press the safety switch (6), then simultaneously

squeeze the ON/OFF trigger (7).

NOTE: When the ON/OFF trigger (7) is released, the

saw will stop immediately due to a brake mechanism.

This prevents the saw blade from spinning after you

have released the trigger. To power the tool back on,

you will need to follow the above stops again.

OPERATION

IMPORTANT: Before cutting any material, always ensure that it is rmly clamped into place and that you will

not be cutting through the table or workbench when adjusting the depth.

NOTE: You can connect a compatible vacuum to the dust extraction outlet (18) to decrease the amount of

dust that is being exhausted from the saw and work area.

GENERAL CUTTING: Never force the saw, always maintain a continuous an light pressure. After completing

cutting cut, always ensure the saw blade has come to cut. When resuming cutting, always allow the saw

blade to reach full speed, then proceed with the cut using rm pressure. When cutting across grain, the

vibration of the wood will have a tendency to lift and tear, moving the saw slowly can minimize the effect.

CAUTION: DO NOT pull the saw backwards