Use and Care Manual

16" SCROLL SAWS
13
GB
1. Take out the adapter. Fix the saw-blade with
allen screws using allen wrench.
2. Extract the saw-blade by sliding the table's
inlay up, then unscrew the clamping screw.
3. Slightly press the upper arm down.
4. Then remove the saw-blade by pulling it
forward out of the supports and through
the access perforation in the table.
5. Put the saw-blade with the two adapter into
the lower support, the other end into the
upper support.
6. Slight press the upper arm down before
hooking it in.
Changing the flat saw-blade (Optional
Feature#2 & #3)
Adapter (
×
2)Flat Saw-blade
Screw M5
×
8 (
×
4)
Table's Inlay
Hook
Lubrication
Lubricate the saw arm bearings every 50
hours. Proceed as above figure shown.
Turn the saw to the side.
Apply a generous amount of SAE 20 oil to the
shaft end and bronze bearings.
Let the lubricant oil work in overnight.
Repeat the procedure the next day on the
other side of the saw.
Oil Seal
7. Tighten the blade with the tightening screw
by rotating it clockwise. Check the tightness
of the blade. Keep on rotating clockwise in
order to tighten the blade even more.
MAINTENANCE