Use and Care Manual

16" SCROLL SAWS
10
GB
Max: 45°
A scroll saw is fundamentally a “curve cutting
tool“ but which can also carry out straight
and angled edge cuts. Familiarise yourself
with the following important points prior to
commissioning the saw.
7KH VDZGRHV QRW DXWRPDWLFDOO\ FXW ZRRG
You must feed the wood against the saw
blade manually.
7KH FXWWLQJ SURFHVV RFFXUV RQO\ ZKLOH WKH
blade is moving downwards.
)HHGWKHZRRGVORZO\DJDLQVWWKHVDZEODGH
as the saw blade teeth are small and cut
only while moving downwards.
$OOSHUVRQVFDUU\LQJRXWZRUNZLWKWKHVDZ
require training. The saw blade may break
easily during this training time while the
operator is still unfamiliar with the saw.
7KH VDZ LV EHVW VXLWHG IRU VKHHWV RI ZRRG
less than 2.5 cm thick.
)HHGWKHZRRGHVSHFLDOO\VORZO\DJDLQVWWKH
blade and avoid abrupt curves to prevent
the saw blade from breaking, if you wish to
cut wood sheets thicker than 2.5 cm.
6DZ EODGH WHHWK EHFRPHV EOXQW RYHU WLPH
saw blades must be replaced. The saw
blades are sufficient for 1/2 to 2 operating
time depending upon the type of wood.
7U\DQGPDNHVXUHWKDWWKHVDZEODGHIROORZV
the grain of the wood in order to obtain a
This saw is suited also to inside cuts cut not
starting at the edge of the work piece. Proceed
as follows:
'ULOODPPKROHLQWKHZRUNSLHFH
/RRVHQWKHFODPSLQJVFUHZEODGHWHQVLRQHU
and release the tension in the blade.
3ODFHWKHERUHKROHRYHUWKHVDZEODGHVORW
in the work bench.
,QVWDOOWKHVDZEODGHWKURXJKWKHKROHLQWKH
work piece and through the work blade slot,
and fasten the blade to the holders.
:KHQ \RX KDYH FRPSOHWHG WKH LQVLGH FXW
remove the saw blade and then remove the
work piece from the bench.
clean cut.
7KHVDZVSHHGPXVWEHUHGXFHGWRPLQLPXP
when cutting precious and non-terrous
metals.
Inside Cuts
Continuous Operation
It is possible to switch the saw on by pressing
the green "I" button for continuous operation.
In order to switch the saw off, it is necessary to
press the red "0" button.
With the continuously variable electronic speed
control, the cutting speed can be increased by
turning to the right or reduced by turning to
the left.
Warning: Switch off the saw
and remove the mains supply
plug before doing inside cuts in
order to avoid injuries caused by
unintentional activation of the saw.
Red “O” button Speed Switch
Green “I” button
OPERATION