Use and Care Manual

Twist drill and core drill
1. While the power is on, the machine will be in standby mode.
2. . lnstall the cutter, then get the cutter point in
the working position.
3.Turn on the switch for magnetic blocks to absorb the work pieces.
4. Turn on the motor switch, the motor should
be spinning clockwise.
5. Rotate the s
peed-controller
to
choose the required speed for drilling holes.
6. Shake down the handle, get the cutter close to workpiece slowly. When the cutter cut
into the workpiece, the normal supply starts working.
7. After
finishing drilling, shake up the handle to get the cutter go away from the
workpiece. Turn off the motor and magnetic, and remove the machine to start another
drilling.
CAUTION:
The depth of the bottom hole should be at least 5mm greater than tapping
depth. For back of s
crew tap, it needs someone to clear the scraps caused by
screw tap and supplied with enough cooling liquid.
Several working methods and precaution
1.
level
work:
A. Move the magnet drill on the work surface. (Note: magnet contact surface should
be clean
and
smooth. Do not have iron debris)
B. Connect power and open magnetic control switch so the magnet firmly attaches
on the work place.
C. Install required drill and loosen the dial and tighten the top screws. Turn the
rack,so that the drill can align the holes and tighten the top screw. Rotate supporting
bar.
D. Open the drill control switch, so the drilling process. (Note:the feed is generally
0.55mm/r,so not
to
much force
in
order to prevent overload)
E. When processing is complete, turn off the control switch and magnet control
switch and pick up magnetic drill from work surface.
2. Side
work:
A. Insert the plug into power outlet.
B. Lift the magnet drill and make sure the magnet is attached the work surface. Open
the magnet control switch so the magnet is attached to the work surface firmly.
C. Fasten safety rope in order to prevent the magnetic drill from a sudden drop.
4