Operation Manual

Xtreamer DisplayPod USB to HDMI

Adapter User’s Manual
35
Standby and Hibernate, Shut Down and Restart
When the adapter is connected to a computer and an external monitor, if the computer
goes into standby or hibernate mode, the external monitor display goes blank.
When the computer returns to an active state, the external monitor display keeps the same
settings it had before the computer went into standby or hibernate mode. However, if the
secondary monitor was set for extended mode, windows that were previously on the
external monitor will not move back to that secondary monitor. Also, if the secondary
monitor is in extended mode and the computer requires a login after standby or hibernate
mode, the login screen appears on the primary computer monitor, not the external monitor.
If the computer is shut down, restarted and logged in, again the secondary monitor returns
to the same mode as it was before shutdown.
Inferred Modes
Some modes in the DisplayPod GUI are shown with [ ] around them.
This occurs when connecting a monitor with a preferred mode higher than the maximum
supported resolution of the DisplayPod device.
In this case, the preferred resolution of the monitor cannot be supported. However we add
lower resolutions of the same aspect ratio to be tried with the monitor. Modes in square
brackets [ ] imply that these are modes not reported by the monitor, but have been made
available by the DisplayPod software for you to try.
As these are inferred modes from the preferred mode of the monitor, they are not
guaranteed to work with the display.