Instructions / Assembly

Installation & Assembly Instructions
Please contact our Customer Service Division with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 1
Read all instructions completely before installing. Should you have any questions about your
installation, please call Customer Service at 440-248-5480
NOTE: All systems must be secured to structurally sound, flat walls
Step 1. Remove all parts from carton and inventory all components.
Parts Inventory
(1) Panel frame section 24”W x 48”H black (31” Wide @ arm extensions)
(2) Sheets of ¼” tempered pegboard with 1” on center (O.C.) hole spacing
(2) Wall mount angle plates 3” x 3” x 4” long.
(4) ¼” x 1-3/4” Phillips flat head masonry screws (for wall mounting angle attachments)
(2) 3/8”-16 x 2-1/4” Hex head bolt (pivoting pins)
(4) 3/8” Flat washers (for pivoting pins)
(4) 3/8”-16 Hex head nuts (for pivoting pins)
(2) 3/8” Lock washer (for pivoting pins)
(28) 3/4” Self tapping truss screws with #2 Phillips head (for tempered pegboard
attachment)
(2) Plastic end caps
Step 2. Pivoting bolt attachment to arm assemblies: (Refer to figure1-2 close-up.) Using 3/8”-16 x 2-1/4”
hex bolts, slide (1) 3/8” washer onto bolt and then insert bolt with washer through hole in arm
assembly. Once through arm assembly, install another flat washer and secure using (1) 3/8” hex nut and
hand tighten. Repeat step for second arm.
Step 3. Attaching tempered pegboard to each side of frame: (Refer to Figure 1-1) Using the existing
holes in pegboard and #10-3/4” self-tapping screws, square up outer edge of pegboard with the outside
edge of your frame section. Using an electric drill with a high performance #1 or #2 Phillips bit, install
self-tapping screws into each of the corners’ opposite arm assemblies; complete installation using
(figure 1-1 for tap screw layout.) Repeat step for other side. To help expedite installation of pegboard:
Use a center punch or pre-drill where tap screws are to be installed using a 1/8”drill bit.
Step 4. Plastic end caps. Insert plastic end caps into the remaining open ends of you tubular frame.
(Caps do not install on the open ends of the extension arms.)
Note: Before starting Step 5, it will be necessary to determine if your walls are plumb and structurally
sound. It may be necessary to install some type of shim system or header for either or both, top and
bottom wall brackets. (For 2” x 4” studded walls refer to figure 1-4 for header installation.)
B1 - 24x48 XtraWall® Swing Pegboard