Installation Instructions

Install TS100 tire pressure sensor and cycle valve

Attention：cycle valve and margin

opening should be concentric.

Step 1. Tighten the screws to connect the cycle valve and

sensor subject firmly. Paint grease or lubricating oil on rubber

valve rod.

Step 2. Insert the valve rod into valve opening from rim interior，

and connect a standard valve cycle extractor to the end of valve

rod.

Step 3. Pull the valve rod to stuck on the valve opening firmly，

then assemble the bonnet back on valve rod.

Step 1

Unload TS100 tire pressure sensor

Screw out the screw at the end of rubber valve

rod，fetch the sensor subject carefully. Carve up

rubber snap joint and connect a standard cycle

valve extractor to rubber valve，according to pull

the margin to unload cycle valve from valve clack.