User Manual

Page 14 on 20
“Joystick” interface settings (“Classic RC” and “One finger”):
Neutral steering path and Steering path: These settings configure the path your finger
needs to follow (movement of the finger) to start triggering a turn, and also to attain a
maximum turn. They are set by default at 6mm and 5mm.
Motor steering power: In case of difficulty when turning the bird, increase the power to
help by accelerating the change of direction. The default value is 50%.
Throttle path: Set the desired length of the path (movement of the finger) to go from
minimum to maximum power (15mm by default).
Setting available for the Classic RC mode only: Right-handed/Left-handed
This setting allows you to reverse the position of the joysticks that control the throttle and
the steering, to allow the screen to reflect your dominant hand. You can choose between
right or left-handed display (or mode 1 and mode 2 for the RC enthusiasts).
Once your settings are finalised, click on the “Fly” button to return to the flying screen.
Pressing the “RESET” button on the bottom of each setting screen allows you to restore
the factory settings.
Reset
factory
settings
Reverse
the
position
of the
joysticks
“Classic RC” settings
Choix du mode de vol
“One finger” settings
Back to
fly screen