SATA/IDE to USB 2.
XCA-PDSI In the box you will find; - USB2.0 to IDE converter cable for 1.8"/ 2.5"/3.5"/5.
XCA-PDSI
XCA-PDSI USB 2.0 to SATA converter cable for 2.5"/ 3.5"/5.25" SATA Drives 3.5" HDD 2.
XCA-PDSI Using 1.8"/2.5" IDE HARD DISK (Laptop/Notebook Mini HDD) 1.Connect the 44 pin plug of the converter to the 1.8/2.5" HDD 2.Plug in the USB 2.0 plug of the converter into the USB port of your pc (USB 2.
XCA-PDSI Using a 3.5"/5.25" Device (3.5" Hard Drive or 5.25" Optical Drive) 1. Connect the 40 pin IDE plug of the converter to the IDE connector the IDE device 2.
XCA-PDSI 3.Plug in the USB 2.0 plug of the converter into the USB port of your pc (USB 2.0 recommended for full speed) If you use Windows ME/2000/XP, Mac OS Version 9.1 and above or an actual Linux distribution, your device will be automatically recognised by the operating system.
XCA-PDSI Using a 2.5"/3.5" SATA I and SATA II Drive 1.Connect SATA connector to device 2.
XCA-PDSI 3.Plug in the USB 2.0 plug of the converter into the USB port of your pc (USB 2.0 recommended for full speed) NOTE 2.
XCA-PDSI Additional Hints/Trouble Shooting 1. If using a 2.5"/3.5" device you must always use a 100/240V AC power adapter. Only 1.8"/2.5" Hard Drives will run only with USB power supply 2.
XCA-PDSI Use the "Safely Remove" function to remove a device while a pc is running to prevent data loss. If a device is not recognised by your pc try to change the configuration of the Hard Disk from MASTER to SLAVE or CABLE SELECT. Find more of the best and newest at www.xtatix.
