LT-901PH Infrared Sauna Installation & Owner’s Manual Please read this entire manual thoroughly before proceeding with the assembly.
PRECAUTIONS AND INSTRUCTION ATTENTION Please read all instructions thoroughly before using. Serious injury may result if ignore the following warning and instruction. Basic precautions should always be followed when using this electrical equipment. DANGER To avoid the risk of causing burns, fire, electric shock, or other injuries: Connect the power cord to a properly grounded outlet. Using only for its intended use as described in this manual. Don't use accessories not recommended by the manufacturer.
Step 1: Position the Floor Panel Place the floor panel on a flat surface. Before assembly, make sure the floor is flat so that you can maintain a comfortable subsequent installation. (image1) image 1 Step 2: Position the Rear Panel Lift the rear panel into position wedging the bottom of the panel into the channel in the floor panel, you can gently rest the rear panel against the wall of your home. (image 2) 8. Turn on/off the reading lamps. 9. Turn on/off the outdoor lamps.
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. To be on the safe side, children should not use the sauna. Using a sauna after taking alcohol, drugs, or medication can lead to hyperthermia and increase the risk of death. If you are feeling uncomfortable, exit the sauna immediately and consult a doctor. Children should be supervised to ensure that they do not play with the appliance.
Step 6: Place the Bench Surface Panel Please put the bench surface panel in place. WARNING: Pay attention to the risk of electric shock. Don’t connect the power supply until all wires are properly connected. Congratulations! Installation completed! Plug in and power on to enjoy your sauna! Step 7: Place the Front Panel Place the front panel into the slot of the floor panel and push it towards the side panels. Then go inside the sauna and check if the gap is almost invisible.
Control Panel Instruction 1 4 3 Step 4: Position the Right Side Panel Place the right panel into the slot of the floor panel and push it towards the rear panel. Please check if there is almost no visible gap between the outside and the inside of the sauna, then it is already fixed. (image 4) 10 image 4 11 Step 5: Place the Bench Surface Panel Place the Bench Support panel (image5&6) and connect the wires behind (image7&8).
