LT-902CH Infrared Sauna Installation & Owner’s Manual Please read this entire manual thoroughly before proceeding with the assembly.
PRECAUTIONS AND INSTRUCTION ATTENTION Please read all instructions thoroughly before using. Serious injury may result if ignore the following warning and instruction. Basic precautions should always be followed when using this electrical equipment. DANGER To avoid the risk of causing burns, fire, electric shock, or other injuries: Connect the power cord to a properly grounded outlet. Using only for its intended use as described in this manual. Don't use accessories not recommended by the manufacturer.
Step 1: Position the Floor Panel Place the floor panel on a flat surface. Before assembly, make sure the floor is flat so that you can maintain a comfortable subsequent installation. (image1) CONTROL PANEL INSTRUCTION Main Power image 1 On/Off Step 2: Position the Rear Panel Lift the rear panel into position wedging the bottom of the panel into the channel in the floor panel, you can gently rest the rear panel against the wall of your home.
SPECIFICATIONS knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Using a sauna after taking alcohol, drugs, or medication can lead to hyperthermia and increase the risk of death. If you are feeling uncomfortable, exit the sauna immediately and consult a doctor. Children should be supervised to ensure that they do not play with the appliance. HYPERTHERMIA Prolonged exposure in the sauna may cause hyperthermia.
Step 8: Install Ceiling Panel and connect the wires Step 6: Place the Bench Surface Panel Lay the Ceiling Panel on top pf the sauna. Make sure all panels are in the slot of the ceiling panel. Make sure that all wires on the side panel pass through the holes. Finally, connect all the wires in the ceiling panel. Place the bench surface panel (image9), and please make sure to always install the Bench Surface panel before installing the Front Panel, otherwise it will not fit inside due to space limitations.
Step 4: Position the Right Side Panel Other Functions Place the right panel into the slot of the floor panel and push it towards the rear panel. Please check if there is almost no visible gap between the outside and the inside of the sauna, then it is already fixed. (image 4) Retractable hanger image 4 Step 5: Place the Bench Surface Panel Place the Bench Support panel (image5&6) and connect the wires behind (image7&8).
