LT-902GH Infrared Sauna Installation & Owner’s Manual Please read this entire manual thoroughly before proceeding with the assembly.
PRECAUTIONS AND INSTRUCTION SPECIFICATIONS ATTENTION Please read all instructions thoroughly before using. Serious injury may result if ignore the following warning and instruction. Basic precautions should always be followed when using this electrical equipment. DANGER To avoid the risk of causing burns, fire, electric shock, or other injuries: Connect the power cord to a properly grounded outlet. Using only for its intended use as described in this manual.
CONTROL PANEL INSTRUCTION Step 1: Position the Floor Panel Place the floor panel on a flat surface. Before assembly, make sure the floor is flat so that you can maintain a comfortable subsequent installation. (image1) image 1 Pre-set Time Up to 60Mins ℃/℉ switching Pre-set Temps Up to 140℉ Step 2: Position the Rear Panel Place the rear panel in place so that the wooden strip at the bottom of the rear panel is clamped to the floor panel.
WARNING: Pay attention to the risk of electric shock. Don’t connect the power supply until all wires are properly connected. Congratulations! Installation completed! Plug in and power on to enjoy your sauna! knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. To be on the safe side, children should not use the sauna.
Step 6: Place the Bench Surface Panel Step 9: Wire Connection Please make sure all wires from side panels are not pressed in the slot. Make sure that all wires in the top panel are connected. Please make sure to always install the Bench Surface Panel before installing the Front Panel, otherwise it will not fit inside due to space limitations.
Step 10: Screw Fixation Step 4: Position the Right Side Panel When you have finished assembling the sauna , you will need to secure the front & rear walls to side walls with matching screws to make the whole sauna more solid. Place the right side panel in place so that the wooden strip at the bottom of the right side panel is clamped to the floor panel.