User's Manual

Document MV0319P.N
© Xsens Technologies B.V.
MVN User Manual
146
Click “Add”
Sync Type: Start
Recording
Sync Line: Out 1
Pulse Polarity: Rising Edge
Pulse Width = 0µs
12
Skip first = 0
Skip factor = 0
Trigger Once: Uncheck
Click “Add”
Sync Type: Stop Recording
Sync Line: Out 1
Pulse Polarity: Falling
Edge
Pulse Width = 0µs
[12]
Skip first = 0
Skip factor = 0
Trigger Once: Uncheck
Note:
Stop recording time may not be on the last sample recorded.
In any synchronization situation, there should only be one master. It is necessary to elect a master,
either an Awinda Station, or a third party device.
23.7.3 Synchronizing with Noraxon EMG
Synchronization was successfully tested between MT Manager, for the MTw Development Kit and
Noraxon TeleMyo system. While we assume that the results will be just as successful with MVN, this
has not yet been tested.
The steps described below describe how to make it possible for the Awinda Station to send a
synchronization signal (Xsens is Sync Out and Noraxon is Sync In) and how to receive the
synchronization signal (Noraxon is Sync Out, Xsens Sync In).
Of course, care must be taken when placing the EMG electrodes with the straps or suit of MVN.
12
Note that MVN Studio 4.1 use the unit microseconds for pulsewidth. For current users, all previous millisecond
units used should be multiplied by 1000.